CANdo CAN Bus Analyser Netronics Ltd.
Home
Download
Store
Support

  CANdo Interface    (P/N NET50003)
CANdo is a compact USB to CAN interface, that allows a PC to be connected directly to an embedded CAN bus. In conjunction with the FREE CANdo Application software, CANdo provides a simple, yet powerful means of testing & analysing a CAN network. The FREE CANdo SDK allows CANdo to be easily integrated into any Windows based program.
CANdo Interface
CANdo Interface Outline Specification
  • Fully compliant with the CAN 2.0A & CAN 2.0B Bosch specifications
  • ISO 11898-2 (High speed CAN) physical interface
  • CAN baud rate adjustable from 6.25k to 1M baud
  • Recognises CAN data, remote & error frames
  • All CAN frames timestamped
    • 25.6us resolution
    • 20ms + 100ppm accuracy
  • Reports CAN bus status & internal status
  • 3 modes of CAN bus operation - normal, listen only & loopback
  • Supports low level CAN message filtering
  • Fully compatible with higher level protocols such as J1939, DeviceNet & CANopen
  • USB v1.1, 2.0 & 3.0 compatible
  • Powered via the USB port
    • 80mA max. in normal mode
    • 500uA max. in suspend mode
  • Internal firmware upgradeable from PC over USB
  • Complies with the requirements of the EU Directive 2014/30/EU on EMC
  • RoHS compliant
  • FREE CANdo Application software
  • FREE CANdo SDK
CANdo Interface Block Diagram
CANdo Interface Block Diagram
CANdo Interface CAN Connector

The CANdo CAN bus connector is an industry standard DB9 male, as recommended by the CiA (CAN in Automation). The pinouts for the connector are shown in the picture below.
CANdo Connector

Click on the link below to download the CANdo Interface datasheet.

CANdo DatasheetCANdo Datasheet

Notes :
  1. The CANdo Interface contains no internal CAN bus termination
  2. The CAN bus must be terminated at either end with a 120 Ohm resistor, although a single 120ohm resistor will suffice for short cable lengths (< 2m)
  3. For long CAN networks (>10m) & in noisy environments the use of screened, twisted pair wire is recommended
Customised versions of the CANdo Interface are available upon request. Please use the 'Support' page to request further information about this service & the different options available. An MOQ of 20 off generally applies to all custom orders.

LATEST SOFTWARE VERSION
HARDWARE SOFTWARE RELEASED
v6.0 v3.1 14/05/20
v7.0 v4.1 14/05/20
v8.0 v5.0 14/10/22
Note : All product versions are fully backwardly compatible.

If you would like to update your device with the latest software, please send a request via the 'Support' page.
CANdoISO Interface  :  CANdoISO Module  :  CANdo AUTO Module  :  CANdo Application  :  CANdo SDK
Home : Download : Store : Support
© 2006-24 Netronics Ltd. Privacy Policy